beautypg.com

On-screen display remote control others – Sony VPL-AW15 User Manual

Page 52

background image

52

On-screen display

Remote control

Others

Symptom

Cause and Remedy

The picture is too dark.

c Adjust the contrast or brightness of the Picture

menu

properly. (

1 page 41)

The picture is not clear.

c Adjust the focus using the focus ring. (1 page 24)
c Condensation has accumulated on the lens. Leave the projector

for about 2 hours with the power on.

The picture flickers.

c Activate “APA”, then adjust the current input signal.
c Adjust “Phase” for “Adjust Signal” in the Screen

menu

properly. (

1 page 45)

Symptom

Cause and Remedy

On-screen display does not
appear.

c Set “Status” in the Setup

menu to “On.” (

1 page 46)

c Check if the

?

/

1

(On/standby) indicator should light in green.

The model name does not
disappear from the screen.

c The display mode of the projector may be set at the time of

purchase. Consult with your local dealer or qualified Sony
personnel.

Symptom

Cause and Remedy

The remote control does
not work.

c Batteries could be weak. Replace them with new batteries.

(

1 page 11)

c Insert the batteries with the correct polarities. (1 page 11)
c If there is a fluorescent lamp near the remote control detector, the

projector may work improperly or inadvertently.

Symptom

Cause and Remedy

The fan is noisy.

c Check the setting of “Cooling Setting” in the Setup

menu.

(

1 page 46)

c Make sure that the room temperature is not too high.

The number of fan rotation increases to maintain the product
reliability of the projector’s components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.

This manual is related to the following products: