Helmet mount, Flipup headset – ATN NVG-7 User Manual

Page 5

helmet mount

(optional)

Helmet mount for attachment of ATN’s NVG-7 to a standard PASGT helmet. Helmet mount fits

securely onto helmet via a rugged strapping device and grooved hooks. With helmet mount,

NVG-7 can be positioned directly in front of user’s eyes or flipped.
inStallation
1) Install the mount onto helmet as shown on the picture.
2) Tighten and fixate the straps [1]
3) Attach goggles to the rail. Push button [2] and insert

the bracket of the NVG-7 to the rail of the mount.
4) Place the helmet on your head.
aDJuStment
1) Loosen the screw [3] and move the unit along the rail

for eye relief adjustment. Tighten the screw [3].
2) Loosen the top vertical fixation screw [4]. Adjust gog-

gle vertical position. Tighten vertical position screw.
3) The NVG-7 helmet mount has a flip-up mechanism. Push a button [5] on the side of mount

and lift the unit up till fixation in the top position.

flipup heaDSet

fittinG the heaDGeaR

1) Fit the headgear to your head size. Adjust the head-

gear fist before attaching the NVG-7 to it.
2) Loosen all the straps and place the headgear onyour

head.
3) Tighten the straps until the headgear fits firmly.

GooGleS inStallation anD aJuStment

Now you are ready to mount the NVG-7 on to your
headgear.

1) Remove the already adjusted headgear from your

head.
2) Push button [1] and insert the bracket [2] of the

NVG-7 to the rail of the headset.
3) Place the headgear with NVG-7 onto your head.
4) Loosen the screw [3] and move the unit along the rail

for eye relief adjustment .

The NVG-7 headset has a flip-up mechanism. Push the

button [4] on the side of mount and lift the unit up until the

unit fixates in the top position.
Push same button to lower NVG-7 to viewing position.
If you need increase the eye relief of your goggles, you

can displace the bracket on the top of NVG-7.

1) Unscrew the screw and detach the end-cap from

the bracket of NVG-7.
2) Unscrew the 2 screws and detach the bracket from

the NVG-7 body.
3) Turn the bracket 180 degrees.
4) Screw the 2 screws back into place.