Alpine CDA-9811 - Manual (Page 32)

30
-EN
Remote Control
Controls on Remote Control
1 Power Button
Press this button to turn the power on/off.
2 Source Button
Press this button to select the audio source.
3 -/J Button
Press this button to switch between the Play and Pause
modes for CD.
4 TILT 98 Buttons
Press this button to adjust the angle of the movable
display.
5 Band/Program Button
Radio mode: BAND Button
Press this button and the band will change.
CD/Changer mode: To switch the disc mode.
6 Volume Adjustment Buttons
To increase the volume level:
Press the
L button
To decrease the volume level:
Press the
K button
7 8 Button
Radio mode: Pressing this button will select, in ascending
order, stations programmed into the radio's presets as
shown below.
1 → 2 ... 6 → 1
CD Changer mode: DISC Select (UP) button
Press this button to select a disc in ascending order.
MP3/WMA mode: Press the Folder Select (UP) button to
select the folder.
8 g DN Button
Radio mode: SEEK (DN) Button
CD mode: Press this button to go back to the beginning of
the current track.
9 f UP Button
Radio mode: SEEK (UP) button
CD mode: Press this button to advance to the beginning
of the next track.
! 9 Button
Radio mode: Pressing this button will select, in
descending order, stations programmed into the radio's
presets as shown below.
6 → 5 ... 1 → 6
CD Changer mode: DISC Select (DN) button
Press this button to select a disc in descending order.
MP3/WMA mode: Press the Folder Select (DN) button to
select the folder.
" Mute Button
Press this button to lower the volume by 20 dB instantly.
Press this button again to cancel.
# Audio Processor Button* 1
CDA-9815/CDA-9813 only
Each press the button to switch the audio processor
mode.
For details, refer to "Operating the Audio Processor" as
shown below.
CDA-9815/CDA-9813/CDA-9811
Press the button to call the external audio processor
mode when the external audio processor is connected.*
2
* 1 This button is used for CDA-9811 in conjunction with an optional
Ai-NET processor.
* 2 For the operation of external audio processor, refer to the Owner's
Manual of the external audio processor you purchased.
Operating the Audio Processor
1
Press A.PROC to select the mode.
Normal mode → EQ mode (Equalizer Presets) → Private mode
(Recalling the Stored Equalizer Curve) → Time Correction
mode (Recalling the Stored Time Correction) → Crossover
mode (Recalling the Stored Crossover) → Normal mode
2
Press 8 or 9 to select the mode.
EQ mode
Select from FLAT, POPS, ROCK and NEWS.
Private mode/Time Correction mode/Crossover mode
Select from MEMORY 1 through 6.
1
2
3
4
#
!
9
"
6
5
7
8