Agri-Fab 45-02932 - Manual (Page 5)

5
FIGure 7
10. Assemble the boom mount bracket to the rear of the
frame tubes using two 5/16" x 2" hex bolts and 5/16"
nylock nuts.
See figure 5.
FIGure 5 rear VIew
11. Assemble the boom bars to the boom mount bracket
using two 5/16" x 1-1/4" carriage bolts, tooth lock washers
(between the bar and bracket), 5/16" flat washers and
knobs. The boom connecting hose should extend upward.
See figure 6.
noTe: Make sure the nozzles are adjusted so that the
openings face straight down when the boom bar is in the
horizontal operating position.
FIGure 6
5/16" NYLOCK NUT
5/16" x 2"
HEX BOLT
CARRIAGE BOLT
5/16" x 1-1/4"
KNOB
5/16" FLAT
WASHER
WASHER
(TOOTH LOCK)
BOOM BAR
BOOM CONNECTING HOSE
SPRAY GUN
CLIP (LARGE)
SPRAY GUN
CLIP (SMALL) #10 x 3/8"
SCREW
#10 LOCK
WASHER
12. Assemble the large and small spray gun clips to the
side of the tank using two #10 x 3/8" screws and #10
lock washers. See figure 7.
enGlIsH