Sony KP-57WS510 - Manual (Page 71)

71
Model name1[KP-46WT510] Model name2[KP-51WS510] Model name3[KP-57WS510] Model name4[KP-65WS510]
[4-094-605-11]
Other Information
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to control
with the projection TV’s remote control, use the following procedures to
program the remote control.
From the “Manufacturer’s Codes” listed on page 73, select the three-digit
code number for the manufacturer’s code for your component. If more than
one code number is listed, start with the number listed first. Use the code
number to complete the following procedure.
To program a cable box or a satellite receiver
1
Open the panel of the remote control.
2
Press CODE SET inside the panel.
3
Close the panel and press SAT/CABLE (FUNCTON) .
4
Enter the three-digit manufacturer’s code number using the 0-9 buttons.
5
Press ENTER .
6
To check if the code number works, aim the projection TV’s remote
control at the component and press the green
POWER button that
corresponds with that component. If it responds, the programming is
completed. If not, try using the other codes listed for that manufacturer.
Sony
Equipment Switch Position
on Remote Control Programmable
Code Number
Beta, ED Beta VCRs AV1 303
8 mm VCR AV2 302
VHS VCR AV3 301
DVD Player DVD 751
✍
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.