Connecting a digital tv receiver – Sony KP-57WS510 User Manual
Page 28
Installing and Connecting the Projection TV
28
Model name1[KP-46WT510] Model name2[KP-51WS510] Model name3[KP-57WS510] Model name4[KP-65WS510]
[4-094-605-11]
Connecting a Digital TV Receiver
Disconnect all power sources before making any connections.
1
Using three separate component video cables, connect the Digital TV
Set-top box’s Y, P
B
and P
R
jacks to the projection TV.
2
Using an audio cable, connect the Digital TV Set-top box’s Audio OUT
jacks to the projection TV’s AUDIO IN jacks.
✍
The Y, P
B
and P
R
jacks do not provide audio, so audio cables must
be connected to provide sound.
✍
Component video connection is necessary to view 480p, 720p, and
1080i formats. You may also use the S VIDEO or Composite Video
connections, however, component video (Y, P
B
, P
R
) will provide the
best picture quality for all format types.
Be sure to read the
Set-top box manual.
Some Digital TV
Receivers are equipped
with a DVI connection.
Refer to your Digital TV
Receiver manual for
setup instructions using
this connection.
z
z
VMC-10HG (not supplied)
Digital TV Set-top box
RK-74A (not supplied)
AUDIO-R (red)
AUDIO-L (white)
Rear of projection TV
P
R
P
B
Y
✍
You cannot record the signal from any equipment connected into the
Y, P
B
and P
R
connectors.
✍
This projection TV is not compatible with digital TV receivers
configured with RGB or VGA output connectors.
✍
The DVI connection is compliant with the EIA-861 standard and is
not intended for use with personal computers.