Slide the battery lead into the fuse block – Alpine MRV-F900 User Manual
Page 15
11
-
EN
3
3
5
1
4
10
2
2
6
7
9
8
9
8
4
1
5
10
3
Slide the battery lead into the fuse block.
•
Slide the battery lead (sold separately) into the fuse block (supplied) as below:
1) Dismantle the fuse box.
Turn the cap
1
counterclockwise.
2) Turn the hexagon screw
3
of the fuse terminal
2
with a hexagon wrench (supplied).
3) Remove the rubber ring
4
and the metal ring
10
. (They are not used. They are for
protection during transportation.)
4) Slide the battery lead
5
(sold separately) through the cap
1
.
5) Insert the tip of the battery lead
5
into the inner part of the fuse terminal
2
.
6) Tighten the hexagon screw
3
of the fuse terminal
2
securely with the hexagon wrench
(supplied).
7) Insert the fuse
6
(80A, supplied) as shown in the illustration below.
*
Fit the projection
8
of the fuse holder
7
into the grooves
9
of the fuse terminal
2
.
4
Turn the hexagon screw of the power terminal. Insert the exposed wire end into
the lead terminal. Tighten the Hexagon screw with the Hexagonal Wrench (In-
cluded), to fix the lead. (Fig. 9)
Before making this connection, use insulated shrink tubing to cover any exposed
wire extending beyond the terminal.
NOTES:
• Use only the Hexagon screws included.
• For safety reasons, connect the battery leads last.
• To prevent disconnection of the leads or dropping of the unit, do not use the cabling to
carry the unit.
To the battery terminal
of the product
To the vehicle's battery
** AWG4 or larger
** AWG4 or larger
* Remove
* Remove
Lead
Hexagon Screw
Fig. 9
Lead Terminal
Fig. 8