AEG FAVORIT 45003 - Manual (Page 24)

Put the appliance adjacent to a water tap and a
water drain. Remove the appliance worktop to
install it under a sink unit or a kitchen worktop.
Make sure that the dimensions of the recess
agree with the given dimensions.
Do these steps to remove the appliance worktop:
1. Remove the rear screws (1).
2. Pull the worktop from the behind the ap-
pliance.
3. Lift the worktop and move it from the
front slots.
4. Use the adjustable feet to adjust the level
of the appliance.
Install the appliance under the kitchen work-
top. Make sure that there are no kinks in the
water hoses and that the water hoses are not
squashed.
If a repair is necessary, the appliance must be easily accessible for the engineer. Install the
appliance worktop to the appliance if you want to use the dishwasher as a freestanding
appliance.
The plinth on freestanding appliance is not adjustable.
Adjusting the level of the appliance
Make sure that the appliance is level to close and seal the door correctly. If the level of the
appliance is correct, the door does not catch on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the adjustable feet until the appliance is level.
24 Installation