AB Soft IN2106 - Manual (Page 24)

23
Using the audio
Using the projector’s speaker
To use the projector’s speaker, connect your source to the Audio In Com-
puter or Video connectors.
To adjust the volume, press the Volume buttons on the keypad or remote.
Troubleshooting Audio
If you aren’t hearing the audio, check the following:
• Make sure the audio cable is connected to the correct Audio In connec-
tor, Computer or Video.
• Make sure the volume is turned up enough. Press the Volume button
on the keypad or remote.
• Make sure the correct source is active.
• Make sure that you are connected to an “audio out” connector on the
source as opposed to a “line-in” or “microphone” connector.
• Adjust the audio source.
• If playing a video, make sure the playback has not been paused.
Connecting external speakers
The projector can be attached to external amplified speakers by connecting a
3.5mm stereo audio cable from the Audio Out connector on the projector to
the amplified speakers. Alternatively, you can bypass the projector’s audio
system and connect the audio directly from your source to a stereo or home
theater system.
connect audio cable
adjust volume
external speakers
speaker
cable
audio out
with own power source