Airlink RT210W - Manual (Page 4)

To check the connection to the Internet, you can open the Web browser and go
to a website. You can also go to the
System Overview page of the router’s
Web -based configuration utility. The WAN Interface group will display the
current connection information.
Congratulations! You’ve successfully configured your Router .
You should customize the SSID and Channel settings as needed. For added
security, you should enable WEP encryption and firewall following instructions
from the manual included in the CD.
6
Checking the Connection to the Internet
7
Quick Configuration for Bridge Mode
If you want to have the device to act as a bridge, follow the steps below.
*Ignore this section if your device is to be configured as a router
Part 1. Enable bridging function.
Go to the WAN configuration page and select the Bridging option as
the WAN/LAN relation and then click Apply to commit the changes.
Part 2. LAN configuration.
Go to the LAN configuration page and then:
1. In the Protocol item, select DHCP Client or Manual Config as
required. If you select DHCP Client, skip to step 4.
2. If you select Manual Config, manually enter the IP address and its
subnet mask in IP Address & Subnet Mask fields.
3. For Manual Config setting only, if you choose to enable DHCP
server service, enter related settings.
4. Click Apply to apply the changes.
8
Technical Support
Email: [email protected]
Website: www.airlinkplus.com
Note: After applying these settings, your configuring computer may lose
connection to the device. To reconnect, you will need to make sure the
computer uses an IP address in the same subnet as the device.