Autostart Two-Way Led Transmission Remote Starter - Manual (Page 10)

P. 10 User Guide
• Flashing LED
ON : the L.E.D. will flash at all times (either under active arming or under passive
arming) to indicate that the starter kill is active.
• Active Arming: the LED will flash normally.
• Passive Arming: the LED will not flash during the countdown preceding the activation of
the Starter Kill. Once the Remote Car Starter is armed, the LED will flash at a normal rate.
• In Valet Mode: the LED will remain lit without flashing.
• Flashing LED
OFF : the LED will not flash even when the module is armed (either under active or
passive arming). Nevertheless, if the module enters valet mode, the LED will still remain lit
without flashing as long as the ignition is off.
Multi-car Operation
This option allows the owner of two vehicles, both equipped with the same Remote Car Starter
model, to control both systems with a single remote control.
To control the second vehicle :
• Press TRUNK + LOCK buttons simultaneously: ...................................... LOCK
• Press TRUNK + UNLOCK simultaneously:............................................... UNLOCK
• Press TRUNK + START/STOP simultaneously :.....................................................START
• Press TRUNK + START/STOP simultaneously : ......................................... STOP
• Press SHIFT ¾ SHIFT ¾ TRUNK: ............................................................. TRUNK
or
• Press SHIFT ¾ SHIFT ¾ LOCK : ............................................................... LOCK
• Press SHIFT ¾ SHIFT ¾ UNLOCK : ........................................................... UNLOCK
• Press SHIFT ¾ SHIFT ¾ START/STOP: ....................................................................START
• Press SHIFT ¾ SHIFT ¾ START/STOP: ..................................................... STOP
• Press SHIFT ¾ SHIFT ¾ TRUNK: ............................................................. TRUNK
Note: If the multi-level features have been modified from their default state by your installer,
the
SHIFT button may have to be pressed once, twice or three times, according to the option
you chose.
Multi-Level Features ( default state)
The multi-level features allow you to access different features of your vehicle or of a second car by
pressing the shift button once, twice or three times. By default, the multi-level features are
programmed as follows:
Basic features (press the SHIFT button 1X)
SHIFT ¾ LOCK: ...............................................................aux 2
SHIFT ¾ TRUNK:.............................................................status request
SHIFT ¾ START/STOP ...................................................cold weather
Multi-car operation (press the SHIFT button 2X)
SHIFT ¾ SHIFT ¾ LOCK:............................2 nd car lock
SHIFT ¾ SHIFT ¾ UNLOCK:.......................2 nd car unlock
SHIFT ¾ SHIFT ¾ START/STOP: ...............2 nd car start/stop
SHIFT ¾ SHIFT ¾ TRUNK:..........................2 nd car trunk
Customized features (press the SHIFT button 3X)
(May not be applicable for certain vehicles)
Your installer can add customized features such as turning on the radio, opening sliding doors, etc.
SHIFT ¾
SHIFT ¾ SHIFT ¾..........................LOCK: customized feature 1
SHIFT ¾ SHIFT ¾ SHIFT ¾..........................UNLOCK: customized feature 2
SHIFT ¾ SHIFT ¾ SHIFT ¾..........................TRUNK: customized feature 3
SHIFT ¾ SHIFT ¾ SHIFT ¾..........................START/STOP: customized feature 4