Sony DVP-NS300 - Manual (Page 53)

Us
ing Va
ri
ous
Addition
a
l Func
tions
53
Controlling Your TV with
the Supplied Remote
By adjusting the remote signal, you can
control your TV with the supplied remote.
1
Hold down TV [/1, and enter your TV’s
manufacturer’s code (see the table
below) using
C/X/x/c.
2
Release TV [/1.
Manufacturer’s codes of controllable
TVs.
Notes
•
If you enter a new manufacturer’s code, the code
previously entered will be erased.
•
When you replace the batteries of the remote, the
code you have set may be reset to the default setting.
Set the appropriate code again.
Controlling the TV
By adjusting remote signal, you can control
the sound level, input source, and power
switch of your TV with the supplied remote.
You can control your TV using the buttons
below.
Note
Depending on the units being connected, you may not
be able to control your TV or to use some of the
buttons.
Controlling TVs with the remote
Manufacture Press C / X / x / c to input code
Sony (default) X X
General Electric X C
JVC x X
Panasonic c c
Philips X c
Quasar c x
RCA X C
Samsung x c
Sanyo X x
Sears c C or X C
Sharp c x
Toshiba c C
Zenith c X
TV [ / 1
C / X / x / c
By pressing You can
TV [/1 Turn the TV on or off
VOL (volume)
+/– Adjust the volume of the TV
TV/VIDEO Switch the TV’s input source
between the TV and other input
sources
TV [ / 1
VOL +/–
TV/VIDEO