AGFA TM 14ADV - Manual (Page 91)

4-6 User’s Manual
Installing an Interface Expansion Board
Selecting the Serial Interface
The printer’s standard interface is parallel. When the serial interface
board is installed, the printer automatically detects that the computer
is using the serial interface.
Verifying Serial Parameter Settings
Next, you must make sure the serial parameter settings are the same
between the computer and the printer. The reference manual
explains the parameters. Consult your computer and software
documentation to determine the settings your computer uses. Then
compare these to the printer’s settings in the following table.
Item Parameter setting (default)
Baud rate 9600
Data bits 8
Stop bits 1
Parity None
Flow control DTR HI
Printer port COM1
06 Chapter 4 07.08.1997, 11:41 Uhr 6