AT&T 3658B User Manual
User’s manual part 2
Table of contents
Document Outline
- CONTENTS
- BEFORE YOU BEGIN
- INSTALLATION
- Table/Desk Installation
- About Handset Registration
- Register an Additional Handset (Model 5800 Handset)
- Wall Installation
- 1 Connect the power cord and telephone line cord to the underside of the base, as shown (figure a).
- 2 Position the mounting bracket as shown (figure b).
- 3 Feed the telephone line cord through the hole in the center of the mounting bracket (figure b), align the bracket with the base, and slide it into the hole on the base as shown (figure c).
- 4 Lock the mounting bracket in place (figure d).
- 5 Plug the telephone line cord into a modular wall jack, and mount the base on the wall (figure e).
- 6 Plug the power cord into an electrical outlet not controlled by a wall switch (figure e).
- 7 Follow Steps 3–5 in “Table/Desktop Installation.”
- Spare Battery/Power Failure Backup
- Belt Clip
- Headset
- FEATURE SETUP
- TELEPHONE OPERATION
- INTERCOM OPERATION
- PHONE BOOK
- CALLER ID OPERATION
- Answering system operation
- BATTERIES
- IN CASE OF DIFFICULTY
- PHONE
- If the phone does not work at all, check these items first
- If you have no dial tone:
- If you hear two beeps when you try to use the handset
- To re-initialize the handset and base
- If you hear noise or interference when using the phone
- If your handset displays ENTER BASE ID or NO BASE SUBSCRIPTION
- If the phone does not ring when you receive a call
- CALLER ID
- ANSWERING SYSTEM
- If messages are incomplete
- If you have difficultyhearing messages
- If callers are unable to leave messages in Mailbox 2 or 3
- If the system does not answer after the correct number of rings
- If CL appears in the message window
- If the system does not respond to commands form a remote touch tone phone
- If your outgoing announcement isn't clear
- PHONE
- DEFAULT SETTINGS
- TECHNICAL SPECIFICATIONS
- INDEX