Asus P5L-MX - Manual (Page 70)

2-24 Chapter 2: BIOS setup
DRAM Write Recovery Time [4 Clocks]
Sets the DRAM Write Recover Time. Configuration options: [2 Clocks]
[3 Clocks] [4 Clocks] [5 Clocks] [6 Clocks]
Hyper Path 3 [Auto]
Set this item to enabled to reduce bottlenecks of memory bandwidth.
Set it to disabled for safe mode. Configuration options: [Auto] [Disabled]
[Enabled]
DRAM Throttling Threshold [Auto]
Allows you to enable DRAM Thermal Throttling to make your system more
stable. Configuration options: [Disabled] [Auto]
Hyper Path 3 [Auto]
Set this item to enabled to reduce bottlenecks of memory bandwidth.
Set it to disabled for safe mode. Configuration options: [Auto] [Disabled]
[Enabled]
Booting Graphic Adapter Priority [PCI Express/Int-VGA]
Allows selection of the graphics controller to use as primary boot device.
Configuration options: [Internal VGA] [PCI Express/Int-VGA]
[PCI Express/PCI] [PCI/PCI Express] [PCI/Int-VGA]
Internal Graphics Mode Select [Enabled, 8MB]
Sets the internal graphics mode.
Configuration options: [Disabled] [Enabled, 1MB] [Enabled, 8MB]
Graphics memory type [Auto]
Sets the graphics memory type. Configuration options: [Auto] [DVMT]
[FIX] [DVMT+FIX]
Boot Display Device [Auto]
Configuration options: [Auto] [CRT on Port 0] [LFP on Port 2] [LFP on
Port 3] [DFP on Port 2] [DFP on Port 3] [TV on Port 2] [TV on Port
3] [CRT-Port 0 & CRT-Port 2] [CRT-Port 0 & CRT-Port 2] [CRT-Port 0
& LFP-Port 2] [CRT-Port 0 & LFP-Port 3] [CRT-Port 0 & DFP-Port 2]
[CRT-Port 0 & DFP-Port 3] [DFP-Port 2 & DFP-Port 3]
Flat Panel Type [Type 1]
Configuration options: [Type 1] [Type 2] ~ [Type 16]
Local Flat Panel Scalig [Auto]
Configuration options: [Auto] [Forced Scaling] [Disabled]