Apple Xserve (Power Supply Replacement) - Manual (Page 2)

Xserve Power Supply - 2
4. If the hard drives are in the locked position (the yellow security LED on the front panel
is on), use the Allen key that came with the server to unlock them.
5. If the cable management arm is not in use, unplug all external cables except the
power cord.
6. Touch the server’s metal case to discharge any static electricity.
Important: Always ground yourself by touching the server’s case before you touch
any parts or install any components inside the server. To avoid static electricity
building back up in your body, do not walk around the room until you have completed
your work and closed the computer.
7. Unplug the power cord.
8. Release the two thumb screws at the front of the server. (Figure 1)
Note: The thumbscrews are captive and do not separate from the bottom housing.
Figure 1