American Dryer Corp. MLG32PDB - Manual (Page 22)

18 Maytag Co. 113062 - 16
Providing local codes permit, power to the dryer can be made by use of a flexible U.L. listed power
cord or pigtail (wire size must conform to the rating of the dryer), or the dryer can be hard wired
directly to the service breaker panel. In both cases, a strain relief must be installed where the wiring
enters the dryer.
NOTE: Contact factory for electrical information not listed.
NOTE: Manufacturer reserves the right to make changes in specifications at any time without notice or
obligation.
ELECTRICAL SERVICE SPECIFICATIONS (PER TUM BLER)
A separate circuit breaker must be provided for each tumbler/pocket.
NOTES: Circuit breakers are thermal/magnetic (industrial) motor curve type ONLY. For others,
calculate/verify correct breaker size according to appliance amp draw rating and type
of breaker used.
SERVICE
VOLTAGE
PHASE
WIRE
SERVICE
APPROX.
AMP DRAW
MINIMUM
WIRE SIZE
CIRCUIT
BREAKER
120 1Ø 2 8.7 * 15
* AWG Stranded Wire Type...size wire as per National Electrical Code or local codes.
8/5/08