Alpine CDE-9873 - Manual (Page 14)

12
-EN
01GB04CDE9873.fm
ALPINE CDE-9873 68-05946Z84-A (EN)
Adjusting Bass/Treble/Balance (Between
Left and Right)/Fader (Between Front
and Rear)/Defeat
1
Press Rotary encoder (AUDIO) repeatedly to
choose the desired mode.
Each press changes the mode as follows:
SUBW * BASS TREBLE BAL FADER DEFEAT
VOLUME SUBW
Subwoofer : 0 ~ +15
Bass level: –7 ~ +7
Treble level: –7 ~ +7
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35
• If no operation is performed for 5 seconds after selecting the SUBW,
BASS, TREBLE, BAL, FADER or DEFEAT mode, the unit
automatically returns to normal mode.
* When the subwoofer mode is set to OFF, its level cannot be adjusted.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting Defeat ON, previously adjusted settings of BASS
and TREBLE will return to the factory defaults.
Setting the Bass Control
You can change the Bass Frequency emphasis to create your own tonal
preference.
1
Press A.SEL/SETUP repeatedly to select the BASS
mode.
BASS TREBLE HPF BASS
2
-1 Press BAND to select the desired bass center
frequency.
80Hz 100Hz 200Hz 60Hz 80Hz
Emphasizes the displayed bass frequency ranges.
2
-2 Press SOURCE/ to select the desired bass
bandwidth.
Changes the boosted bass bandwidth to wide or narrow. A
wider setting will boost a wide range of frequencies above
and below the center frequency. A narrower setting will
boost only frequencies near the center frequency.
2
-3 *1 Turn the Rotary encoder to select the desired
bass level (–7~+7).
You can emphasize or weaken the bass level.
3
Press and hold /ESC for at least 2 seconds to
return to normal mode.
• If no operation is performed for 15 seconds, the unit will return to
normal mode automatically.
• The bass level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The bass
frequency and bass bandwidth settings adjusted for one source are
effective for all other sources (FM, AM, CD, etc.).
• The function is inoperable when DEFEAT is set to ON.
* 1 The adjustment can also be made by pressing Rotary encoder. Refer
to “Adjusting Bass/Treble/Balance (Between Left and Right)/Fader
(Between Front and Rear)/Defeat” (page 12).
Sound Setting
BAND
Rotary encoder (AUDIO/LOUD)
A.SEL/SETUP
SOURCE/
/ESC
Setting the Bass Center Frequency
Setting the Bass Bandwidth
Setting the Bass Level
01GB00CDE9873.book Page 12 Friday, September 22, 2006 5:17 PM