Step 2: installing the drive carriers – Adaptec FS4100 User Manual
Page 7
6
3
Remove the tower’s front bezel, as shown below, saving the
screws for use in
.
4
Turn the enclosure 90° so that the right hand rack mount ear
and LEDs are on top, then slide the Storage Enclosure into the
tower skin, as shown above.
5
Replace the front bezel, using the screws removed in
6
Install the tower labels at the top and bottom of the tower. Align
the holes in the top label with the LEDs on the enclosure.
7
Replace the drive carriers and APCs, if necessary.
The tower assembly installation is complete. Continue with
, below.
Step 2: Installing the Drive Carriers
These instructions assume that the drive carriers have already been
attached to your disk drives.
Caution:
Acclimate new disk drives to room temperature
before you install them and power up the Storage Enclosure.
To install the drive carriers into the Storage Enclosure:
1
Hold the drive carrier with the LEDs on the left side (at the
bottom for tower-mounted systems) and select an open disk
drive slot.
Note:
It is easiest to install the drive carriers from left to
right on the Storage Enclosure.
Step 3
Step 4
!