Auto Page RS-660 User Manual

Page 6

VALET MODE:

The valet switch allows you to temporarily bypass all system function,
eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in valet mode, and remote start
functions are bypassed, however the remote panic feature and remote
door locks will remain operational. To use the valet mode, the system
must first be deactivated either by using you remote transmitter, or by
operating the Manual override sequence.
Enter Valet Mode:

1. From the Unlock condition, turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds until the LED turns on. The

LED will remain on as long as the system is in ‘valet mode’.

Exit Valet Mode:

1. Return to normal operation, turn ignition ‘on’.

2. Push and hold valet switch for 2 seconds, The LED will turn off

indicating the system has exited the valet mode.

PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually
trigger the vehicle’s siren / horn in case of emergency.

1. Press and hold the

button for 3 second. The siren / horn will

immediately sound.

2. During panic mode, the normal function of this transmitter button will

be suspended. The

and

buttons can be used to lock and

unlock the doors (if the option is installed), however once the button
is pressed, the vehicle’s starter disable device, (where installed) will
be enabled allowing the vehicle to start.

3. To stop the panic, press and hold the

button on the

transmitter again for 3 seconds. Also if any transmitter button other
than the

button is pressed and released, the panic mode

will be turned off immediately.

4. If no buttons are pressed, the panic function will stop automatically

in 60 seconds.

TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away with 3 long chirps from

siren/horn.

2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the

ignition key will all trigger the programmed sequence.

The starter disable relay (if installed) prevents the vehicle’s starter from
cranking. The siren, horn, parking lights, and dome light will turn on
alerting of an intrusion for 30 seconds. Then it will stop and automatic
reset and re-arm. If one of the sensors or detectors is still active, the