AT&T TL7610 - Manual (Page 18)

12
Getting started
Battery installation
Install the battery as shown below. After installing the battery,
you may be able to make and receive short calls. For optimal
performance, charge the headset battery for at least six hours
before use. When the headset is not in use, recharge the headset
by returning it to the headset base.
NOTE: Remove the ear hook from the headset (see page 16) before battery
replacement.
2. Insert the battery into the battery
compartment with the label THIS
SIDE UP facing up.
3. Push the battery plug into the
connector inside the compartment
according to the color-coded label
and place the wires neatly inside
the compartment.
4. Insert the tab on the bottom of
the battery cover into the battery
compartment. Press down gently
on the battery cover until it snaps
into place.
4
2
3
1. If the battery door is attached,
press on both sided of the battery
compartment cover and lift the
cover up and off.
1