AT&T TL7610 - Manual (Page 15)

9
Getting started
Headset base installation
Option 2: Headset base stand-alone installation (TL7610)
In order to make calls, you need a telephone plugged into the
same telephone line or a dial pad (TL7601 sold separately).
NOTE: For more information about the accessory dial pad (model TL7601), visit
our website at
www.telephones.att.com
.
2. Plug one end of the
telephone line cord into
the
TEL WALL JACK (red
dot) at the back of the
headset base.
DSL filter (not included) is
required if you have DSL
high-speed Internet service.
Telephone
line cord
3. Plug the other end
of the telephone
line cord into a
telephone jack.
4. Plug the headset
base power adapter
into an electrical
outlet not controlled
by a wall switch.
1. Plug the small end of
the headset base power
adapter into the
POWER
jack (green dot) at the
back of the headset base.