Audiovox PS-2351 - Manual (Page 7)

Piercing Speaker Mounting Holes
1. Opening
2. Speaker
3. Pierce the speaker mounting holes
Using an Existing Hole
1. Speaker
2. Drill
3. Drill the required speaker mounting
holes
-7-
Enlarging or Cutting a New Hole
1. Enlarge or cut new hole per template
2. Tape
3. Template
4.
Metal cutting saw
5. File hole smooth after cutting
Cutting Door Padding and Piercing Speaker Mount-
ing Holes
After routing the speaker wires, perform the final installation as
follows:
1. Replace door panel, window crank, etc. Press against door
panel to locate speaker hole. Then, using a sharp knife or
box cutter, cut out opening in padded door panel.
2. Replace speaker in opening and pierce the three or four
speaker mounting holes. Remove speaker.