Alpine TME-S370 - Manual (Page 17)

15
-EN
Adjusting Picture Contrast
Low (-15) to High (+15) (Default Setting: 0)
Touch [ ▲ ] or [
▲
] adjust object contrast on the
screen. When it reaches the minimum or maximum
contrast level, the display shows “Low” or “High,”
respectively.
Adjusting Picture Sharpness
Soft (-15) to Hard (+15) (Default Setting: 0)
Touch [ ▲ ] or [
▲
] adjust the sharpness or clarity
of the edge of an object appearing on the screen.
When it reaches the minimum or maximum
sharpness level, the display shows “Soft” or “Hard,”
respectively.
Visual EQ Mode
Off (Default Setting) / Night Movie / Soft / Sharp /
High Contrast
Off: The default setting.
Night Movie: Suitable for movies containing dark scenes.
Soft: Suitable for CGs and animated fi lms.
Sharp: Suitable for old movies where images are
not clearly shown.
High Contrast: Suitable for recent movies.
• When any picture setting is changed, the Visual EQ
item name is changed to “Custom.”
Reset Display Setting
Reset only affects the individual display setup
sources. Any picture setting can be reset without
affecting the other settings.
When pressing the Reset button, the message,
"Reset display values to default?" appears. Press
"Reset" to go back to the factory setting.
Information
In Case of Diffi culty
If you encounter a problem, please turn the unit
power off, then on again, or turn the vehicle ACC
off, then on again.
If the unit is still not functioning normally, please
review the items in the following checklist. This
guide will help you isolate the problem if the unit
is at fault. Otherwise, make sure the rest of your
system is properly connected, or then consult
your authorized Alpine dealer.
Basic
No function or display.
• Vehicle’s ignition is off.
If connected according to the instructions, the unit will
not operate with the vehicle’s ignition off.
• Improper power lead connections.
Check power lead connections.
No sound or unnatural sound.
• Connections are not properly or securely made.
Check the connections and fi rmly connect.
Screen not displayed.
• Brightness control is set at the minimum position.
Adjust the Brightness control.
• Temperature in the vehicle is too low.
Increase the vehicle’s interior temperature to
operation temperature range.
• Connections to the DVD, navigation system are not
securely made.
Check the connections and fi rmly connect.
Navigation system inoperative.
• Connections to the navigation system are incorrect.
Check the connections with the navigation system and
connect the cables correctly and fi rmly.
290533_TME370_r13.indb E15 290533_TME370_r13.indb E15 7/29/09 1:29:15 PM 7/29/09 1:29:15 PM