Audiovox Rampage 6.0 Inch - Manual (Page 8)

128-6825
8 of 10
Routing Speaker Wires
1. Door Frame
2.
Kick Panel
3. Connect speaker wires to speakers
4. Route wires to stereo
5. Drill 1/4” hole or use existing grommets
6. Door (open)
Securing Speaker and Grille
1. Mesh Grille
2. Speaker mounting screws
3. Speaker
4. Grille
3. Place speaker into door and secure using screws (and clips,
if necessary) provided with speaker.
4. Test the speaker. Then install grille (grille snaps over outer
ring of speaker frame). Repeat for remaining door.
-8-
Routing Speaker Wires
Route the speaker wires as follows:
1. Route speaker wires from stereo into door. If possible, use
existing wires. If door is not equipped with grommets, drill
a 1/4” hole in door edge and door frame.
2. Connect wires to speaker per stereo wiring instructions.
Allow enough slack between door edge and frame to fully
open door. DO NOT tape wires to hinges or braces.
1
2
4
3