beautypg.com

Assembly instructions – Agri-Fab 45-02103 User Manual

Page 4

background image

4

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1) Pliers
(1) Hammer
(2) 7/16" Open or Boxed End Wrenches

1.

Remove the spreader, the loose parts and the hardware
package from the carton. Lay out parts and hardware
and identify using the illustrations on pages 2 and 3.

2.

With the spreader resting upside down on the top of
the hopper, assemble a spacer and then a 5/8" flat
washer onto each end of the axle. See figure 1.

FIGURE 2

FIGURE 1

FIGURE 3

5.

Place a wheel onto the end of the axle that has a cross
hole. The long end of the hub goes to the inside. See
figure 3.

6.

Assemble a 5/32" x 2" cotter pin through the hole in
the wheel hub and the axle. See figure 3.

7.

Place a 5/8" flat washer onto the axle and then lightly
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See figure 3.

FIGURE 4

3.

Place a wheel onto the end of the axle that has no
cross hole. The long end of the hub goes to the inside.
See figure 2.

4.

Place a 5/8" flat washer onto the axle and then lightly
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See figure 2.

AXLE

SPACER

5/8" FLAT

WASHER

5/8" FLAT
WASHER

HUB CAP

WHEEL

NO CROSS HOLE

HUB CAP

5/32" x 2"

COTTER PIN

CROSS

HOLE

5/8" FLAT
WASHER

8.

Remove the nut from the middle bolt in the crossover
tube. See figure 4.

CROSSOVER
TUBE

MIDDLE NUT

SHAFT
SUPPORT
PLATE

MIDDLE BOLT