Cyclades PR1000 User Manual
Page 35
Cyclades-PR1000
35
Chapter 4 - Step-by-Step Instructions
STEP TWO
No more parameters are necessary for the Ethernet interface. The other interface to be configured is the SWAN
in slot 1. The SWAN physical media parameters are shown in Figure 4.13. Fill in the values for your application.
The SWAN configuration is described in more detail in chapter 6 of the Installation Manual.
Menu CONFIG=>INTERFACE=>SWAN=>PHYSICAL
Parameter
Example
Your Application
Mode
Synchronous.
Clock Source
When the interface is connected to a
DSU/CSU, the
Clock Source
is
External
.
Media for SWAN Cable
V.35 in the example because the DSU/CSU
is V.35. The type of cable is detected by the
router, so if the correct cable is connected to
the DSU/CSU the router will choose this
value as the default.
FIGURE 4.13 SWAN PHYSICAL MENU PARAMETERS