Cyclades PR1000 - Manual (Page 34)

Cyclades-PR1000
34 Chapter 4 - Step-by-Step Instructions
STEP ONE
The first step is to determine the parameters needed to configure the Ethernet interface (ETH0). The parameters
in the Network Protocol Menu (IP) are shown in Figure 4.12. Fill in the blanks for your application in the right-most
column. These parameters will be entered into the router later, after all parameters have been chosen. Each
parameter in this menu is explained in more detail in chapter 5 of the Installation Manual.
M enu C O N FIG =>IN TE R F A C E =>E TH E R N E T=>N E TW O R K P R O T O C O L=> IP
P aram eter
E xam p le Y our A pp lication
A ctive or Inactive A ctive enables IP com m unication (IP X and
Transparent B ridge are not used in this
exam ple).
Interface U nnum bered N um bered
P rim ary IP A ddress 100.130.130.1
S ubnet M ask 255.255.255.0
S econdary IP A ddress 0.0.0 .0 for none .
IP M TU U se the preset value, 1500. This determ ines
w hether or not a g iven IP da tagram is
fragm ented.
IP Fragm entation - Ignore
B it D F Y es.
N A T G lobal, because N A T is not being used in this
exam ple.
IC M P P ort Inactive
Incom ing R ule List N one, filters are not included in this exam p le.
O utgoing R ule List N am e N one, filters are not included in this exam p le.
R outing o f B roadcast
M essages Inactive
P roxy A R P Inactive
FIGURE 4.12 ETHERNET NETWORK PROTOCOL MENU PARAMETERS