Karcher NT 27-1 Professional - Manual (Page 12)

-
2
1 Nameplate
2 Power cord
3 Holder for suction pipes
4 Holder for crevice nozzle
5 Suction hose
6 Suction head lock
7 Steering roller
8 Dirt receptacle
9 Suction support
10 Floor nozzle
11 Suction pipe
12 Main switch
13 Suction head
14 Carrying handle
15 Cable hook
16 Bender
17 Cartridge filter
18 Fastening nut
19 Float
Caution
For dry vacuuming, the cartridge filter must
always be installed.
– To vacuum fine dust, you can also use
an additional paper filter bag.
Illustration
Illustration
Î
Release and remove the suction head.
Î Insert the paper filter bag.
Î Insert and lock the suction head.
Illustration
Î
Remove the brush strips.
Î Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
– To suck wet dirt, first remove the paper
filter bag.
Î Release and remove the suction head.
Î Turn the suction basket by 180° and
keep it aside.
Î Loosen the mounting nuts
Î Remove the cartridge filter.
Illustration
Î
Insert the fastening nut and tighten it.
Î Install the additional filter.
Î Insert and lock the suction head.
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
Î Plug in the main plug.
Î Switch on the appliance at the main
switch.
– The vacuum channel is equipped with a
float.
– When the dirt water reaches the highest
permissible level in the container, the
suction power is interrupted.
Î Switch off the appliance at the main
switch.
Î Empty the dirt container.
Î Switch off the appliance at the main
switch.
Î Pull out the mains plug.
Î Empty the dirt container.
Î Vacuum and wipe the appliance inside
and outside with a damp cloth.
Device elements
Start up
Dry vacuum cleaning
Inserting the paper filter bag
Wet vacuum cleaning
Inserting the rubber lips
Remove the paper filter bag
Installing an additional filter
Clip connection
Operation
Turning on the Appliance
Emptying the dirt container
Turn off the appliance.
After each operation
12 EN