Karcher Puzzi 200 - Manual (Page 12)

– 3
 Press the suction switch to turn on the
suction turbine.
Press the spray switch to turn on the de-
tergent pump.
see Figure 5
ṇ
Warning
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.

Use the lever on the bender to spray on
detergent solution.
Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
see Figure 6
 In case of work interruptions, the floor
nozzle can be stored in the handle.
see Figure 12
 If the dirt water reservoir is full, switch
off the suction and spray switches.
 Remove the lid.
 Remove the dirt water reservoir from
the appliance and empty it.
see figures 7 and 8
 Spray and suction off detergent solution
in one work cycle.
Note: Repeated suctioning without spray-
ing will shorten the drying time.
 Apply detergent solution with suction
turbine turned off and soak for 10 to 15
minutes.
 Clean the surface just like with normal
soiling.
 In order to further improve the cleaning
result, the surface can be recleaned us-
ing clear, warm water.
– Highly soiled spots should be pre-
soaked and the detergent solution
should soak 5 to 10 minutes.
– Always work from the light to the shade
(from the window to the door).
– Always work from the cleaned to the un-
cleaned surface.
– The more sensitive the surface (oriental
rugs, berbers, upholstery material) the
lower the cleaning solution concentra-
tion should be.
– Rugs with jute backing can shrink if too
much water is used and can bleed col-
ours.
– Brush high-fiber rugs in the direction of
the weave after cleaning (using a fiber
brush or a scrubber).
– Water-proofing the fabric using Care
Tex RM 762 after the wet cleaning pre-
vents a quick resoiling of the textile sur-
face.
– Do not step on cleaned surfaces until
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.
– When cleaning previously shampooed
carpets, foam will be generated in the
dirt water reservoir. In such a case add
Foam ex RM 761 to the dirt water reser-
voir.
If you require further information please re-
quest the product information sheet and the
DIN safety data sheet for the respective
cleaning agent.
Empty the dirt water reservoir.
Cleaning methods
Normal soiling
Strong soiling or stains
Cleaning tips
Detergent
Carpet and upholstery
cleaning RM 760 powder
RM 760 tabs
RM 764 liquid
Defoaming RM 760
Waterproofing carpets RM 762
Mite removal RM 765 Mitex
12 EN