Karcher Puzzi 200 - Manual (Page 11)

– 2
Illustrations on Page 2
1 Casing
2 Carrying handle
3 Fresh water tank with sieve
4 Dirt water reservoir, removable
5 Cover
6 Switch for spraying
7 Switch for vacuuming
8 Spray/suction hose
9 Power cord
10 Suction pipe
11 Manual nozzle for upholstery cleaning
(option)
12 Container for defoamer (Puzzi 200)
13 Storage container for detergent tabs
(Puzzi 200)
14 Additional socket for professional PW 10
15 Floor nozzle for carpet cleaning
16 Handle
17 Bender
 Place suction pipe over floor nozzle and
tighten union joint on the floor nozzle
fingertight (left thread).
Caution
While connecting make sure that the spray
tubes meet in the suction pipe and the floor
nozzle.

If needed, slide handle onto suction
pipe and attach in the desired position
using the enclosed hexagon socket
wrench.
 Place the elbow over the suction pipe
and tighten the union joint on the elbow
fingertight.
Caution
While connecting make sure that the spray
tubes meet in the suction pipe and the el-
bow.
Illustrations on Page 2

Insert the suction hose into the suction
hose connection on the appliance.
Insert the coupling of the fresh water
hose into the fresh water connection of
the appliance and lock into place.
see Figure 1
 Connect the suction hose to bender of
the manual nozzle.
Connect the coupling of the fresh water
hose to the bender and lock into place.
see Figure 2
The manual nozzle for upholstery cleaning
(not included) is attached directly to the
suction hose without the use of an elbow.
* not included in the delivery
Illustrations on Page 2

Mix fresh water and detergent in a clean
container (use the concentration rec-
ommended for the detergent).
see Figure 3
ṇ
Warning
Health risk, risk of damage. Observe all in-
dications on the detergent used.
Note: Warm water (max. 50°C) will in-
crease the cleaning effect.
Note: For considerate treatment of the en-
vironment use detergent economically.

Fill detergent solution into the fresh wa-
ter reservoir. The fill level must not ex-
ceed the "MAX" mark.
see Figure 4
 Insert dirt water reservoir into the appli-
ance and attach lid.
 Plug in the main plug.
Device elements
Start up
Selecting the nozzle
Carpeting Floor nozzle
(230 mm)
Upholstery, wall rugs,
automobile interior
cleaning Manual nozzle
(110 mm) *
Stairs Carpet nozzle *
Operations
11 EN