Karcher KMR 1250 Lpg - Manual (Page 23)

KMR 1250 LPG
User Instructions
English
45
Troubleshooting
Problem Possible cause Remedy
Engine does not start Battery is flat Recharge or replace battery
Gas cylinder empty Replace gas cylinder
Gas cylinder closed Open gas cylinder
Engine oil level is too low Top up with oil
Sweeper does not move Lever (bypass valve) on
converter transmission is open Push lever in opposite
direction to travel – see
“Pushing the sweeper by
hand”
Brushes do not rotate V-belt has snapped Call Customer Service
V-belt is loose Check belt tension and adjust
as required
Main brush or side brush has
been jammed by packing bands
or similar item Remove blockage
No dust extraction Fan is not working Check V-belt
Filter is blocked Clean or replace filters
Poor sweeping results Brushes are worn down Replace brushes
Waste hopper is full Empty waste hopper
Incorrect sweeping pattern Adjust sweeping pattern
Dust is stirred up during
sweeping Worn out seals on sweeper, filter
not fitted properly or defective Replace defective seals; fit
filter correctly or replace it
Lifting mechanism for
emptying hopper does not
work Fuse has blown Replace fuse or inform
Customer Service if fuse
blows repeatedly
Defective switch Inform Customer Service
Defective hydraulic unit Inform Customer Service
Sweeper travels forwards
or backwards even though
drive pedal is not pressed Neutral position not set up
correctly Inform Customer Service