Karcher KMR 1250 Lpg - Manual (Page 13)

KMR 1250 LPG
User Instructions
English
35
Cleaning the filter Automatic cleaning
n
Stop the sweeper and switch off the engine.
After the engine has been switched off, the filter is automatically cleaned
for approx. 10 seconds.
Manual cleaning
While the sweeper is operating, the filter should be cleaned approx. every
15–30 minutes (depending on amount of dust).
n Stop the sweeper.
n
Set the sweeping mode lever to wet .
n
Switch on the electric filter cleaner for approx. 10 seconds .
n
Set the sweeping mode lever back to dry .
n Continue with cleaning task as before.
Emptying the
waste hopper Important information
Injury hazard!
No person or animal should be allowed to stand in the area traversed by the hopper
while it is being emptied.
Danger of being crushed!
Do not reach into the shafts and linkage of the emptying mechanism.
Do not stand under the hopper.
Risk of sweeper toppling over!
If the sweeper is standing on a slope with a gradient of more than 5%, it could topple
over while the hopper is being emptied. The hopper should therefore only be emptied
when the gradient at the location where the sweeper is standing is less than 5% for
the direction in which it is facing.
n
Stop the sweeper.
n Raise the main brush
Note: Following steps can only be performed with the sweeper set to two-handed
operation.
n Raise the waste hopper,
1 + 2 +
When the hopper has reached the required height:
n
Tip the hopper outwards, 1 + 3 +
Note:
The hopper must have reached a certain minimum height before it can be tipped out.
The best position for emptying the hopper is when it has been fully extended.
As soon as you release the button for activating the tipping system, the hopper
automatically returns to its original position.
n Lower the hopper,
1 + 4 +