Karcher Aspirateur eau et poussières NT 65-2 Ap Me - Manual (Page 13)

– 2
1 Electrodes
2 Suction hose
3 Push handle
4 Suction head lock
5 Wheel
6 Dirt receptacle
7 Suction head
8 Steering roller
9 Suction support
10 Chassis
11 Floor nozzle
12 Suction tube
13 Main switch
14 Carrying handle
15 Filter cover
16 Button for filter shake off system
17 Hose switch
18 Bender
19 Storage for floor nozzle
20 Holder for suction pipes
21 Power cord
22 Holder for crevice nozzle
23 Cable clamp
24 Nameplate
25 Filter dedusting
26 Flat fold filter
– The operating elements for the cleaning
process are yellow.
– The controls for the maintenance and
service are light gray.
Caution
The flat pleated filter must always be in
place while vacuuming.
– When vacuuming fine dust, you may
also use an additional paper filter bag or
a membrane filter (special accessory).
Illustration

Release and remove the suction head.
 Insert the paper filter bag or the mem-
brane filter (special attachment).
 Insert and lock the suction head.
Illustration

Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
– If the appliance is used to vacuum wet
dirt the paper filter bag or the mem-
brane filter (special accessory) must al-
ways be removed.
– It is recommended to use a special filter
bag (wet) (see Filter systems).
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if mostly wa-
ter is suctioned from a container it is
recommended not to activate the
"manual filter dedusting" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Device elements
Colour coding
Start up
Dry vacuum cleaning
Inserting the paper filter bag
Wet vacuum cleaning
Inserting the rubber lips
Remove the paper filter bag
General
13 EN