Karcher SE 4001 - Manual (Page 15)

– 8
 Insert the filter cover and turn to lock.
 Install the motor casing. Pull up on
the carrying handle to lock.
Illustration

Install the fresh water reservoir. In-
sert the bottom part first and then press
toward the top on the motor compart-
ment to check if it is locked in.
Illustration

Slide the spray handle onto the handle
until it locks into place.
 Attach the spray hose of the spray han-
dle to the suction hose using 7 mount-
ing clips.
 Attach the suction hose and the spray
hose to the connectors on the appli-
ance.
Note: Press the suction hose tightly into
the connector to lock it into place.
Illustration

Connect the suction tubes and attach to
the handle.
 Insert the loose spray hose in the spray
handle and attach to the suction tubes
using the 3 included mounting clips.
 Attach the floor nozzle to the suction
tubes and insert the spray hose into the
floor nozzle. Rotate the exterior safety
lever and lock the spray hose into
place.
The appliance is now prepared for wet
cleaning.
ṇ
Caution
Always work with an inserted foam filter
- during wet as well as dry vacuum
cleaning!
ṇ
Caution
Check the object to be cleaned prior to us-
ing the appliance in an inconspicuous place
for colour fastness and water resistance.
Do not clean water-sensitive floor cover-
ings such as wood floors (the moisture
could penetrate and damage the floor).
Note:
Warm water (max. 50°C) will increase the
cleaning effect.
 Work without the hard surface insert.
Please only use the carpet cleaner RM 519.
 Slide the attachment for hard surfaces
onto the spray ex floor nozzle from the
side. The bristles should point towards
the back.
Note: You can remove the water reservoir
to fill it or you can fill it directly on the appli-
ance.
Illustration

Flip the reservoir cover up.
 Add 100 - 200 ml (volume depends on
degree of contamination) of RM 519
into the fresh water reservoir, then add
tap water - do not overfill.
 Close the reservoir cover.
Illustration

Insert the mains plug into the socket.
 Press the switch for suction (position I),
suction turbine is running.
Illustration

Close fully the surrounding air separa-
tor at the handle.
Illustration

Press the switch for spraying (position
I), the detergent pump is ready.
 Use the lever on the spray handle to
spray on detergent solution.
Operations
Wet cleaning of carpets/hard
surfaces
Wet cleaning of carpeted floors
Wet cleaning of hard surfaces
Fill up fresh water reservoir
Start working
15 EN