Karcher HDC advanced - Manual (Page 21)

English 21
You can use the steam gun without any ad-
ditional accessories.
Application:
– elimination of odours and creases from
garments: Apply steam to the hanging
garment from a distance of 10–20 cm.
– Removing dust from plants: Respect a
distance of 20-40 cm.
– dusting with a damp cloth: Apply a small
amount of steam to a cloth, and then use
this cloth to wipe over the furniture.
The closer you hold the nozzle to the dirty
spot, the higher the cleaning effect as tem-
perature and pressure of the steam reach
their maximum values immediately when
they are emitted from the nozzle.
Application:
– Fittings, drains
– Wash-basins, toilets
– Blinds, radiators
– Stain removal: Moisten stubborn lime-
stone with vinegar, and allow to react for
approximately 5 minutes.
Note: The round brush is not suited for the
cleaning of delicate surfaces.
The extension piece is attached to the detail
nozzle.
Application:
– locations that are difficult to access, such
as corners and joints
– Fittings, drains
Pull the terry cloth cover (E2) over the man-
ual nozzle.
Application:
– small, washable surfaces, such as kitch-
en surfaces made of plastic, tiled walls
– Shower cabins, mirror
– Furniture fabrics
– Vehicle interior, windshields
– Bath-tubs
Application:
– Windows, mirrors
– Glass surfaces on showers
– other smooth surfaces
Î
Perform a fat dissolving basic cleaning
using the manual nozzle (E1) and a terry
cloth cover (E2) before the first cleaning
using the window nozzle.
Î Apply steam to the glass surface from a
distance of approximately 20 cm until the
surface is moistened evenly.
Î Strip the glass surface in straight lines
from the top to the bottom using the rub-
ber lip of the window nozzle. Wipe the
rubber lip and the bottom edge of the
window dry after each strip.
Application:
– all washable wall and floor coverings,
e.g.: Stone floors, tiles, and PVC floors.
Î Attach the floorcloth (H3) to the floor noz-
zle (H1). Fold up the floorcloth length-
ways, and place the floor nozzle on the
cloth. Pull the jutting out ends of the
floorcloths one after the other under the
retaining clips (H2) (see Fig. 5 ).
Figure 5
Î To remove the cloth, press the retaining
clips (H2), and pull out the cloth.
Î Turn and exchange the floorcloth in reg-
ular intervals. Thus, you improve the
ability to pick up dirt.
Î Work slowly on very dirty surfaces to al-
low the steam to act on the dirt for a long-
er period of time.
Steam gun (C1)
Detail nozzle (D1)
Round brush (D2)
Manual nozzle (E1)
Squeegee (F1)
Floor nozzle (H1)