Karcher KM 80 W P - Manual (Page 14)

- 6
Troubleshooting
Fault Remedy
Engine does not start
Reduced motor output Check setting of gas lever
Refuel
Open fuel cock
Drain bad or old fuel from the tank and the carburettor, fill in fresh fuel
Check and clean spark plug, replace if necessary.
Check air filter, clean if required.
Check bowden cable to the motor
Inform Kärcher Customer Service.
Engine is too hot Have the carburettor adjusted.
Fill in motor oil
Engine is running but machine is
not moving Adjust the Bowden cable of the acceleration drive
Inform Kärcher Customer Service.
Machine is not sweeping properly Check roller brush for wear, replace if necessary.
Lower or raise the roller brush by means of the height adjustment
Readjust Bowden cable of the sweeping drive
Inform Kärcher Customer Service.
Technical specifications
Machine data
Length x width x height (pushing handle unfolded)
mm 1410 x 800 x 1060
Length x width x height (pushing handle folded in) mm 880 x 800 x 770
Net weight (transport weight) kg 70
Driving and sweeping speed km/h 2,1
Climbing capability (max.) % 12
Climbing ability with attachments (max.) % 2
Roller brush diameter mm 300
Working width mm 800
Engine
Type
-- Honda, GCV 135E
1 cyl., four-stroke
Cylinder capacity cm 3 135
Max. speed 1/min 2860 ±10
Minimum speed 1/min 1700 ±10
Max. power kW/PS 2,6/3,5
Fuel type Petrol, unleaded
Fuel tank capacity l 0,77
Spark plug, NGK -- BPR 6 ES
Oil grades
Engine oil - type
SAE 10W30
Filling quantity l 0,55
Tyres
Drive wheel
-- 4.00-4
Tyre pressure bar / MPa 1,8 / 0,18
Working conditions
Temperature
°C -5 and +40
Air humidity, non-condensing % 0 - 90
Values determined as per EN 60335-2-72
Noise emission
Sound pressure level L
pA
dB(A) 84
Uncertainty K
pA
dB(A) 3
Sound power level L
WA
+ Uncertainty K
WA
dB(A) 101
Machine vibrations
Hand-arm vibration value
m/s 2 < 2,5
Uncertainty K m/s 2 0,2
Subject to technical modifications!
14 EN