Karcher EB 30-1 Li-Ion - Manual (Page 11)

– 3
see Figure 2
The telescopic strut consists of 3 parts.
While assembling it, make sure that the
parts lock into each other.

Insert the handle on the longer strut
with turning handle.
 Insert together the longer and shorter
struts; while assembling it, press the
locking button.
 Insert the entire strut with the locking
button into the joint on the appliance.
 Loosen the handle and pull out the strut
to the desired working height; turn the
handle to the correct position and tight-
en using the turning handle.
see Figure 3
The battery is not charged at the time of de-
livery. Charge it before commissioning the
appliance and then as and when required.
Note: The battery can be charged only
when it is removed out of the appliance.

Connect the battery to the charger us-
ing the charging cable or rather insert
the battery in the charger.
 Insert the charger delivered with the ap-
pliance into a proper socket.
The charger display glows red. The battery
is being charged.
Charging time for empty battery
Note: If the charging time is exceeded, the
charger shifts to retention charging. The
charger display continues to glow red.
see Figure 4

Insert the battery into the intake and
lock it.
see Figure 5
The Cardan joint can be locked to clean
high-fiber carpets to prevent the telescope
strut from moving from side to side.
– Lock/unlock telescope strut on the side:
 Activate the lock, then move it down
and lock it in.
– Unlock telescopic strut:
 Activate the lock, then move it up and
lock it in.
see Figure 6

Switch on the appliance; press the on/
off foot switch to do so.
 Move the appliance forward and back-
ward to clean it.
 Use the right side (battery side) to clean
the appliance close to the edges.
see Figure 7

Switch off the appliance; press the on/
off foot switch to do so.
 To ensure that the telescopic strut
stands safely during breaks in opera-
tion, hold it vertically; there is a stopper
that holds it in position.
 Switch off the appliance when finished.
 Empty dirt container after each clean-
ing.
 Press the unlocking button of the bat-
tery and remove the battery.
 Charge the battery.
Installing the telescopic handle and
the handle and adjusting the height
Charge the battery
Charger NiCd
6.654-
186.0 Li-Ion
6.654-
257.0 Li-Ion
6.654-
273.0
BC 1/0.1 12 h -- --
BC 1/0.45 -- 3 h 6 h
BC 1/1.8 50 min 45 min 90 min
Insert the battery
Operation
Lock/unlock telescope strut on the
side
Starting the work
Interrupting the work
Finishing your work
11 EN