Karcher VC 6300 - Manual (Page 14)

– 8
Illustration

Push the dead button at the handle and
remove the telescopic suction pipe.
Illustration

Open the attachment housing cover.
Illustration

Insert the handle in the desired acces-
sory until the stop. It then gets locked.
Then tilt it downwards and pull it out.
Illustration

To store, put the attachment using the
handle into the attachment housing and
click it up into place. Remove the handle.
 Notice: You also can remove the at-
tachment manually and put it on top of
the handle. In order to release the at-
tachment, push the dead button on the
handle.
 Notice: All steps stated above can also
be done when the telescopic suction
pipe is connected. Hang the floor noz-
zle on the backside of the appliance into
the parking holder, and push into the
pause position. Pull the telescopic suc-
tion pipe straight up.
Illustration

Carpets and carpeted floors:
Select the following switch setting:
Illustration

Hard surfaces:
Select the following switch setting:
 Turn off the appliance and disconnect
the mains plug.
Illustration

Push the take-up cable button. The ca-
ble will pull itself automatically into the
appliance.
 Hang the floor nozzle on the backside
of the appliance into the parking holder,
and push into the pause position.
 Hold the appliance at the carrying han-
dle when you want to transport it and
store it in dry rooms.
Note: It is recommended that you first
completely push in the telescopic suc-
tion pipe.
ƽ
Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
ṇ
Caution
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.

Clean the appliance and accessory
parts made of plastic with a commercial
plastic cleaner.
 Clean the dust chamber with a dry wipe
cloth/ dust brush.
Order no. 6.904-329
Contents: 5 filter bags with cap and 1 en-
gine protection filter.
Note: Separate the telescopic suction pipe
from the handle to see the filter change in-
dicator.
Illustration

If the filter change indicator in the cover
glows red, then please change the filter
bag.
 Use the closing lever and open the lid.
Illustration

Unlock the holder of the filter bags and
pull towards the outside.
Illustration

Close the filter bag using the closing
flap, remove the filter bag and dispose it
off.
ComfoGlide nozzle
Finish operation
Transport, storage
Maintenance and care
Cleaning the device
Replacing the filter bag
14 EN