Haltech Platinum PRO PLUG-IN Nissan Patrol Y61 2002 - 2009 (HT055014) - Manual (Page 4)

ECU Installation
To install your new Platinum Pro Plug-in to your Nissan Patrol Y61, please follow the
procedures below.
• Please Note the following Installation photos based on a Nissan Patrol Y61 (ADM)
with an aftermarket alarm and trailer brake controller installed.
You will require the following tools
• Phillips #2 Screwdriver
• Side Cutters
• Socket Set with 10mm socket and extension bars
• Cable Ties / 3M Double sided tape or similar
1. With Ignition key switched to OFF, locate your factory ECU.
This will be located on the drivers side of the vehicle behind the center console,
to the left side of the clutch pedal.
Figure 1 – ECU Location
ECU Pinout
Figure 12 – Platinum Pro Plug-in Nissan Patrol Y61 ECU Pinout