Haltech Platinum PRO PLUG-IN Nissan Z32 300ZX (HT055007) User Manual
Page 7
Rear Auxiliary Connector
The Platinum Pro Plugin Series allows further expansion of your ECU by the
Rear Auxiliary Connector.
The Rear Auxiliary connector allows you access to:
•
2 Additional Digital Pulsed Outputs ( DPO )
•
2 Additional Digital Switched Outputs ( DSO )
•
2 Additional Analogue Voltage Inputs ( AVI )
•
2 Additional Analogue Temperature Inputs ( ATI )
These extra Inputs / Outputs can be used to:
•
Fit additional sensors. (eg. MAP and Temperature)
•
Control additional devices via relays
•
Control additional solenoids directly (eg. Aftermarket Boost Control solenoid)
The Rear Auxiliary harness is available as an optional extra. ( HT040003 )
Figure 9 - Rear Auxiliary Harness Connector and Pin-out
5.
With the ECU installed do not attempt to start the vehicle. You will need to configure
the ECU. The ECU is pre-configured for use with a VG30DETT standard engine.
If this is your setup then you will not have to load a basemap. However, it is still
strongly recommended that you check your settings before starting your engine.
With the corresponding basemap loaded into the ECU, a standard engine should be
able to be started at this point. If your engine is not standard please adjust any
configuration settings affected according to your setup.
Figure 7 – Haltech ECU Manager Software
6.
With the engine started and running its time to tune. This is best achieved by your
nearest engine tuner. See the listing of Haltech dealers on our website to find the one
closest to you.
Figure 8 – Haltech ECU Manager Software tuning page
1
2
3
4
9
10
11
12
5
6
7
8
13
14
15
16
Looking into Back Of Connector
Pin #
Wire Colour
Connection
1
O
+5V
2
Y
AVI1 (MAP)
3
O/B
AVI2
4
B/W
SIGNAL GROUND
5
V/B
DPO1
6
V/BR
DPO2
7
-
-
8
-
-
9
O
+5V
10
GY
ATI1 (AIR)
11
GY/B
ATI2
12
B/W
SIGNAL GROUND
13
V/R
DSO1
14
V/O
DSO2
15
-
-
16
-
-