Haltech Platinum Sport GM (HT051100) - Manual (Page 4)

ECU Installation
To install your new Platinum Sport GM to your vehicle, please follow the
procedures below.
* Please Note the following Installation photos are based on a VQ V8 Statesman
You will require the following tools
• Drill with Sharp 4mm Drill bit ( to remove the security cover if installed)
• Phillips #2 Screwdriver
• Cable ties / 3M Velcro Tape or similar
1. Ensure Ignition is off.
2. Locate your factory ECU. This will be located on the passenger side of the vehicle
behind the kick panel.
If your vehicle has the optioned security cover installed, then remove it by drilling out
the 3 rivets securing it to the vehicle body as in figure 1.
Figure 1 – ECU Location with security cover installed
ECU Pinout
Figure 9 – Platinum Sport GM Pinout