Ferguson Ariva HDplayer 110 - Manual (Page 15)

11
ENGLISH
Getting Started
Step 1: Inserting batteries into the
Remote Control
A
Open the battery compartment.
B
Insert two batteries type R03 or AAA,
following the indications(+ -) inside the
compartment.
C
Close the cover.
Using the Remote Control to operate
the Player
A
Aim the Remote Control directly at the
remote sensor (IR) on the front panel.
B
Do not put any objects between the
Remote Control and Player while
operating the Player.
CAUTION!
– Remove batteries if they are
exhausted or if the Remote Control is
not being used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical
substances, so they should be disposed
properly.
Step 2: Setting up the TV
IMPORTANT!
Make sure you have completed all the
necessary connections.
A
Press POWER on the RCU to turn Ariva
on.
B
Turn on the TV and set it to the correct
video source. You should see the Ariva
background screen.
 The TV Remote Control may have a
button or switch that chooses different
video modes.
C
If you are using external equipment,
(eg. audio system or receiver), turn it on
and select the appropriate input source
for the Ariva player output. Refer to the
equipment owner’s manual for detail.
Selecting the TV system that
corresponds to your TV
This Player is compatible with NTSC, PAL
and HDMI.
A
Press SETUP.
B
Press  to select Video tab
C
Press  to highlight TV System, then
press .
D
Press  to highlight one of the avaible
options.
E
Select a setting and press OK.