AccuTemp EVOLUTION GAS STEAMER - Manual (Page 24)

MP4010-1003 EVOLUTION GAS STEAMER
18
CLEANING - CONNECTED MODELS
DAILY CLEANING
Turn the steamer off and wait for the steamer to cool. 1.
Open the drain valve and allow the cooking compartment to drain completely. Remove the 2.
pan racks, steam collector, overfill sensor and condensate tray for cleaning. Wipe the inside
of the cooking chamber, water sensors, pan rails, steam collector, overfill sensor, and
condensate tray with a clean cloth. Clean the door gasket, inside of door and front face of the
cooking chamber.
Re-install the overfill sensor, steam collector, pan rails and condensate tray. Leave the door 3.
open overnight.
(NOTE: The steamer will not operate without the overfill sensor.)
WEEKLY CLEANING
Close the drain valve and add 1 cup (8 ounces or 0.24 liters) of white vinegar to the 1.
cooking compartment. Start the steamer in the Cook Mode. The cooking compartment will
automatically fill with water. After 15 minutes, turn the steamer off and allow the steamer
to cool. Then open the drain valve and allow the water in the cooking chamber to drain
completely.
To rinse close the drain valve and start the steamer in the Cook Mode. The cooking
2.
compartment will automatically fill with water. After 15 minutes turn the steamer off and allow
it to cool. Open the drain valve and let it drain completely.
Remove the pan rails, steam distributor, steam collector, overfill sensor and condensate tray
3.
for cleaning. Clean the water sensors with a non-metallic cleaning pad.
Wipe the inside of the cooking chamber, water sensors, pan rails (Fig. 13), steam
4.
distributor (Fig. 13), steam collector (Fig. 13), overfill sensor (Fig. 13), and condensate tray
with a clean cloth.
Install the overfill sensor and the steam collector , resting the steam distributor on top of the
5.
steam collector align the 4 retaining fasteners and hand tighten, then install the pan rails and
the condensate tray. Leave the door open overnight.
(NOTE: The steamer will not operate without the overfill sensor.)
WARNING
Warning: Do not use a water jet or pressure washer to clean the steamer
OPERATIONS
STEAM
DISTRIBUTOR
STEAM
COLLECTOR
PAN RAIL
OVER FILL
SENSOR
Fig. 15