AccuTemp EVOLUTION GAS STEAMER - Manual (Page 17)

MP4010-1003 EVOLUTION GAS STEAMER
11
WAter Line COnneCtiOn - COnneCteD MODeLS
The Installer/Owner is responsible for the water connection of this appliance. This appliance is to be installed
to comply with all applicable federal, state, or local plumbing codes. The installation requires a check-valve
(or other approved anti-back flow / anti-siphon device) (not provided) in all supply lines in accordance with and
as required by local, state, and national health, sanitation, and plumbing codes.
See Fig.7
Check local codes to determine exactly what type of anti-back flow / anti-siphon device is •
necessary to meet local requirements.
Design the water supply line so the unit can be moved for service. Install a manual water •
valve between the water supply line and the steamer supply line.
The Garden hose Thread (GhT) connector used must be suitable for potable water •
Do not apply pipe thread sealant to GhT connections. •
Install a manual water shut-off valve (not provided) • between the cold water supply line and the
appliance.
Either hot or cold water can be connected to the steamer. If hot is used, temperature •
must be less than 180°F.
A reinforced rubber or braided stainless steel appliance hose rated for the temperature and •
pressure of the water supply with a 3/4” garden hose type connection is required.
The hose must not be sharply bent, kinked or twisted. •
If the steamer is close to a wall, use a right angle fitting to prevent kinking the hose •
Flush the water supply lines before connecting the lines to the appliance. •
Connect the water supply lines to the steamer. •
QUICK DISCONNECT GAS CONNECTION - CUSTOMER
SUPPLIED
WATER LINE CONNECTION - CUSTOMER
SUPPLIED - 60 PSI MAXIMUM WATER PRESSURE
DRAIN HOSE - CUSTOMER SUPPLIED
Fig. 7
INSTALLATION