A.J. Antunes & Co DFW-150 9100805 - Manual (Page 5)

5 P/N 1010966 Rev. G 08/12
INSTALLATION
NOTE: When placing the unit, make sure
to provide at least 3 inches of space on
all sides of the unit.
1. Remove unit and all packing materials
from shipping carton.
2. The unit should come with the items
listed below:
• Owner’s Manual
• Authorized Service Agency Directory
NOTE: If any parts are missing or dam-
aged, contact Antunes Technical Service
IMMEDIATELY at 1-877-392-7854 or
1-630-784-1000.
3. Remove all packing materials and
protective coverings from the unit.
4. Remove and wash the Pan, False
Bottom, and Pan Diffuser in soap and
water. Rinse with clean water and
allow to air dry.
NOTE: The steam generator surface will
have a white coating of artificial lime
deposits. This coating is necessary for
steaming characteristics.
5. Wipe all surfaces of the unit with a
hot damp cloth.
NOTE: Do NOT use a dripping wet cloth.
Wring out before use.
6. Re-install Pan, False Bottom, and Pan
Diffuser.
When placing the unit into service, pay atten-
tion to the following guidelines.
• Make sure to provide at least 3 inches
of space on all aides of the unit.
• Make sure the power switch is off and
the unit is at room temperature before
plugging in the power cord.
• Do not block or cover any openings
on the unit.
• Do not immerse the power cord or
plug in water.
• Keep the power cord away from
heated surfaces.
• Do not allow the power cord to hang
over edge of table or counter.
Figure 1. Components
Top Cover
Operating
Controls
Tank
Cover
Power
Cord
False
Bottom
Pan
Pan Diffuser
ELECTRICAL
Plug the power cord into the appropriate
power outlet. Refer to the specification plate
for the proper voltage.
1. Place the unit on a sturdy, level table
or other work surface.
2. Turn off the power.
3. Ensure that the line voltage corre-
sponds to the stated voltage on the
units specification label and power
cord warning tag. If you are unsure of
your Line Voltage, contact an electri-
cian.
4. Connect the unit to the power supply.
WARNING
Be sure to follow all the precautions, proce-
dures, and safety steps listed in the Important
Safety Information section of this manual.
WARNING
All electrical connections must be in accor-
dance with local electrical codes and any other
applicable codes.