Jumpers, Default settings, Table 1 – Analog Devices HSC-ADC-EVALC User Manual
Page 5: Figure, Hsc-adc-evalc
HSC-ADC-EVALC
Rev. 0 | Page 5 of 32
ROHDE & SCHWARZ,
SMHU,
2V p-p SIGNAL
SYNTHESIZER
ROHDE & SCHWARZ,
SMHU,
2V p-p SIGNAL
SYNTHESIZER
BAND-PASS
FILTER
USB
CONNECTION
06
67
6-
004
HSC-ADC-EVALC
DATA CAPTURE
BOARD
PC
RUNNING
VisualAnalog
–
+
PS
GN
D
V
RE
G
5V DC
3A MAX
WALL OUTLET
100V TO 240V AC
47Hz TO 63Hz
DATA BUS 2
PARALLEL
LVDS/CMOS
OUTPUTS
EVALUATION
BOARD
DATA BUS 1
PARALLEL
LVDS/CMOS
OUTPUTS
XFMR
INPUT
CLK
SWITCHING
POWER
SUPPLY
SPI
SPI
ONBOARD POWER
SUPPLY
Figure 2. Example Setup Using ADC Evaluation Board and HSC-ADC-EVALC ADC Capture Board
JUMPERS
Default Settings
Table 1 lists the default settings for the HSC-ADC-EVALC evaluation kit.
Table 1. Jumper Configurations
Jumper Number
Description
J9, Pin 1 to Pin 2 (1.8 V)
Default. Sets FPGA I/O voltage to 1.8 V logic (hardwired, do not remove).
J9, Pin 3 to Pin 4 (2.5 V)
Install single jumper here to set FPGA I/O voltage to 2.5 V logic.
J9, Pin 5 to Pin 6 (3.3 V)
Install single jumper here to set FPGA I/O voltage to 3.3 V logic.
Table 2. FPGA Configuration Mode
U4 DIP Switch Setting
M0
M1
M2
M3
M4
FPGA Configured via EEPROM
On
On
On
Reserved
Reserved
FPGA Configured via USB (Default)
On
Off
Off
Reserved
Reserved