beautypg.com

Asus M2N-MX User Manual

Page 61

background image

ASUS M2N-MX

2-21

Configure DRAM Timing by SPD [Enabled]

When this item is enabled, the DRAM timing parameters are set according

to the DRAM SPD (Serial Presence Detect). When disabled, you can

manually set the DRAM timing parameters through the DRAM sub-items.

The following sub-items appear when this item is Disabled. Configuration

options: [Enabled] [Disabled]

DRAM CAS# Latency [5]

Controls the latency between the SDRAM read command and the time

the data actually becomes available. Configuration options: [3] [4] [5]

[6]
DRAM RAS# to CAS# Delay [6 DRAM Clocks]

Controls the latency between the DDR SDRAM active command and

the read/write command. Configuration options: [2 DRAM Clocks] [3

DRAM Clocks] [4 DRAM Clocks] [5 DRAM Clocks] [6 DRAM Clocks]
DRAM RAS# Precharge [6 DRAM Clocks]

Controls the idle clocks after issuing a precharge command to the DDR

SDRAM. Configuration options: [2 DRAM Clocks] [3 DRAM Clocks] [4

DRAM Clocks] [5 DRAM Clocks] [6 DRAM Clocks]
DRAM RAS# Activate to Precha [15 DRAM Clocks]

Configuration options: [4 DRAM Clocks] [5 DRAM Clocks]...[18 DRAM

Clocks]
DRAM Write Recovery Time [4 Clocks]

Set the write recovery timing.
DRAM TRFC [30 DRAM Clocks]

Configuration options: [20 DRAM Clocks] [25 DRAM Clocks] [30 DRAM

Clocks] [35 DRAM Clocks] [42 DRAM Clocks]
DRAM TRRD [10]

Configuration options: [10]

Initiate Graphic Adapter [PEG/PCI]

Allows you to select the graphics controller as the primary boot device.

Configuration options: [PCI/PEG] [PEG/PCI]

Initiate Graphic Mode Select [Enabled, 8MB]

Allows you to select the amount of system memory used by the Internal

graphics device. Configuration options: [Disabled] [Enabled,1MB] [Enabled,

8MB]

PEG Force x1 [Disabled]

Configuration options: [Enabled] [Disabled]