Asus M2N-MX - Manual (Page 55)

ASUS M2N-MX 2-1
2.3.4 IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press
if you wish to configure the item.
IDE Configuration
Onboard IDE Controller [Enabled]
Serial-ATA Devices [Device 0/1]
nVidia RAID Function [Disabled]
Onboard IDE Controller [Enabled]
Allows you to enable or disable the onboard IDE controller.
Configuration options: [Enabled] [Disabled]
Serial-ATA Devices [Device 0/1]
Allows you to disable or set the Serial-ATA devices.
Configuration options: [Disabled] [Device 0] [Device 0/1]
nVidia RAID Function [Disabled]
Allows you to enable or disable the NVIDIA RAID function.
Configuration options: [Enabled] [Disabled]
2.3.5 Primary IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE
devices. There is a separate sub-menu for each IDE device. Select a device
item then press to display the IDE device information.
Third IDE Master
Device : Not Detected
Type
[Auto]
LBA/Large Mode [Auto]
Block(Multi-sector Transfer) M [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
SMART Monitoring [Auto]
32Bit Data Transfer [Enabled]