Nilfisk-ALTO AMX-120 - Manual (Page 12)

11
-. PHONES/CTRL ROOM Control
This control sets the amount of signal sent to the control room and headphone.
23
4.7 PHONES
This socket will send out the mix signal to a pair of headphones.
27
4.4 CTRL ROOM OUTPUT Connectors
These 1/4" sockets are used to send the control room signal to
the studio monitor speakers or a second set of PA.
24
L
L R
TAPE IN TAPE OUT
R
CTRL ROOM OUTPUT
2-TRACK IN/OUT
4.5 2TK IN/OUT Connectors
-. TAPE IN
-. TAPE OUT
Use the tape input if you wish to listen to your mix from a taper
recorder or DAT. You can assign the signal coming from the taper
recorder either to a pair of studio monitor using the control room
assignment on the front panel or you can also send the signal
directly to the main mix.
These RCA jacks will route the main mix into a tape recorder.
25
AUX SENDS
LEFT RIGHT
PHONES MAIN MIX OUTPUT
4.6 AUX SENDS Connector
These 1/4" sockets are used to send out the signal from the AUX
bus to external devices such effects.
26
4.8 MAIN MIX OUTPUT Connectors 28
Through the main mix level control, you can adjust the output level
from -
to +15dB.
The stereo output is supplied with 1/4" TRS sockets, which is used
to send the audio signal to an amplifier.
24
25
26 27 28